Home / Equipment / Camera / Accessories / Tilta Nucleus-M WLCS

Tilta Nucleus-M WLCS

The Tilta Nucleus-M is a revolutionary and highly customisable 3-channel wireless lens control system. It allows you to have full control of focus, iris and zoom on either the FIZ hand unit or between the two wireless hand grips. You can even split control of the channels between the hand unit and wireless hand grips as you see fit with the push of a button.

The wireless range of both the hand unit and hand grips is 1,000 feet and with the planned upcoming transmission upgrade, the range can reach up to 1 ¼ miles! This makes it ideal for drone or car-mounted shots.

The hand grips can be attached to the included rosette mounts for handheld operation and can also be attached to top bar-based gimbals with the included Nucleus-M Hand Grip to Gimbal Adapters.

Each motor has its own built-in motor drive that communicates directly with the hand unit and hand grips. This negates the need to mount a separate MDR to your rig, allowing for a more compact camera setup and a quicker setup time. Simply set the motors and hand unit/hand grips to the same channel and you will have full control.

The motors allow for automatic calibration of the lens as well as manual calibration if you are using lenses that don’t have hard end stops at close focus and infinity.

The motors are designed to clamp onto 19mm or 15mm rods (with the included rod bushings). This clamp-on design allows you to easily attach and detach the motors without needing to remove any other accessory from your setup. Every motor has a 0.8 mod, 35 tooth, 32 pitch gear attached, which is the standard gear size for cinema lenses. The torque of the Nucleus-M Motor at 14.8V is 2.5N·m

Remote start/stop is possible by plugging a compatible Nucleus-M R/S cable into the open 7-pin port of a motor. This then gives you R/S capabilities through the hand unit and/or the handles.

  • Wireless FIZ Hand Unit WLC-T03C
  • Wireless FIZ Hand Unit Strap
  • 1x Right Wireless Handle Unit WLC-T03HR, 1x Left Wireless Handle Unit WLC-T03HR
  • 2x Brushless Wireless Motor WLC-T03M
  • 8x 18650 Batteries + Charger
  • 2x Follow Focus Marking Discs
  • 2x Handle to Arri Standard Rosette Adapters, 2x Handle to Gimbal Bar Adapters 30mm Rod Diameters
  • Lanyard
  • 1x 74cm 7-pin to D-tap Motor Power Cable, 1x 55cm 7-pin to 7-pin Motor Cable, 1x 17cm 7-pin Motor Cable
  • 1x Arri EXT R/S Cable, 1x RED DSMC2 CTRL R/S
Motor Weight

190g

Range

305m