Home / Equipment / Camera / Monitoring / Teradek Bolt Pro 1000 2RX

Teradek Bolt Pro 1000 2RX

The Bolt Pro 1000 transmits visually lossless 4:2:2 video over the unlicensed 5GHz band at less than 1 millisecond of delay. Bolt’s new firmware ensures your system reaches its full potential right out of the box. They also improved reconnect times so your wireless link is restored instantly when you come back into range.

The Teradek Bolt Pro 1000 transmitters are 20% smaller than previous systems, and lighter too. They have also improved their resilience in high heat conditions so that they operate flawlessly all the way up to 54 degrees. Every model supports real-time standards and cross conversion from TX to RX, allowing you to automatically convert resolution, frame rate, and inputs.outputs (HDMI) without any additional hardware. The Panel Array Antenna is your go-to solution for cutting through wireless interference in crowded environments. When attached to a Bolt Pro 1000, the antenna provides and extremely robust directional signal that will ensure your signal arrives uninterrupted.

Perfect for use with MoVI and other gimbals, Bolt’s TX features a built-in HDMI to SDI converter, allowing you to connect both your on-camera monitor and video source via the same device. Both the TX and RX feature 1⁄4”-20 holes for mounting to cameras and monitors as well as 2-pin Lemo connectors for power.

  • Bolt XT 1000 Transmitter 
  • 2x Bolt XT 1000 Receiver
  • Multipanel Antenna 
  • 4x Dtap – 2 Pin Lemo Power Cable, 2x Mains Unit – 2 Pin Lemo
  • 2x Curly BNC Cable, 2x 0.5m ‘Pinky Slinky’ BNC, 1x 1.5m BNC Cable
  • 1x 0.5m HDMI Cable, 1x 1m HDMI Cable
  • Wooden Camera Ultra Arm

Up to 1000 ft


1x 3G-SDI


2x 3G-SDI